LED-Rückleuchten Diskussionsthread

[Dutch Delight]

(20.09.2013 16:56)Aljaz schrieb:  

(20.09.2013 15:33)Dutch Delight schrieb:  Hi Guys,

Received resistor last week from Dectane. As Dectane instructed, connect one wire to the black wire (with the red clip) on the taillight-side connector, and the other wire to the empty pin also on the taillight-connector.

I've asked 3 times Dectane how to connect this wire to the empty pin (do i need to strip some isolation off and then put it in?) but there is totally no response.

Maybe here some idea's ? Thanks in advance !

Dutch Delight:
This clip will itself strip isolation from the cable when you will close it together. The metal part on the clip will go through the cable...that is why there are little holes on the bottom. You just put both cables in before connector and clip this clamp together, so it will push the metal through the cable. Hope you understand now.. if not please let me know

@ Aljaz, off course i understand this part, but Dectane told me to put other wire into the empty connection-pin of the connector on the taillight-unit. There is now no wire in it, so we must put it there.

So my question was how to apply that.